Protect your 300L Rally's vulnerable underside including the exhaust, oil cooler, side cases, etc with SRC's innovative heavy-duty skid plate/crash bar combo!
In regards to a conventional full upper and lower crash bar set for the Rally, It’s SRC’s opinion that the upper front side fairing mount isn’t strong enough for a full crash bar set. The only upper attachment point is on the bikes Rally tower frame and any impacts to the crash bar would end up damaging the tower frame structure, so they developed this kit below. Plus in most falls, the end of the handlebar and footpeg hold the bodywork away from the ground.
The commonly used upper front shroud point is part of the headlight and windscreen tower structure and it would be damaged in a light fall/tip over as it is of light metal construction.
Does not fit the 250L / 250L Rally models *see detail at the bottom of this page regarding installation on the 300L.
Stout 1" (25mm) drawn over mandrel crash bar tube (DOM) with 1/8" (3mm ) wall thickness
Skid plate is made of 11 gauge ( 1/8" / 3mm) thick 304 aluminum sheet with stainless hardware.
Developed for on and off-road use
Cutouts allow access to common service points without the need for removal of skid plate
Weight 16.5 lbs / 7.5kg
* We have had inquiries about fitting this kit to the 300L, and it does fit, but be aware that the crash bars are positioned a couple of inches away from the motor to clear the Rally's bodywork. Here are a few photos from a customer that installed them on his new 300L recently.